AR-15 with Trijicon ACOG and Gemtech M4-02 Suppressor

A free people ought not only to be armed and disciplined, but they should have sufficient arms and ammunition to maintain a status of independence from any who might attempt to abuse them, which would include their own government.  — George Washington

Bushmaster XM15-E2S with Trijicon ACOG TA01 and Gemtech M4-02 PiranhaIf the Founding Fathers, believing that every citizen should be armed to defend his life and liberty, were handing out guns today, every man would get an AR-15.  This is the American arm you can count on to protect your family, property, and fellow man.

The Rifle

There are a number of reputable manufacturers out there building AR-15 rifles to military specifications (the AR-15 is essentially a semi-auto-only version of the M16 infantry rifle), and there are many variations.  Since this is a tactical rifle I believe it should have a collapsible stock and the shortest legal barrel (unregistered), which is 16″: This makes it as easy as possible to store, carry, and use in close quarters if necessary.  If you start with those specifications then the biggest decision you have to make on the rifle is between a handle or flat-top upper.  I like my sights up high and I qualified on the M16-A2 while on active duty, so I went with the former.  There is more flexibility for modifications if you go with the latter.

The rifle itself will set you back about $900.  I bought one of the first available post-sunset (i.e., collapsible stock + flash suppressor + 30-round magazine) Bushmaster XM15’s for a total of $870 in 2004.  Since the standard grip is too small for my hands, I spent $20 to replace it.

Sights

The standard M16A2 sight system is very effective:  Using these sights at a long-range FrontSight course I was able to reliably hit man-sized targets at 400 yards from a kneeling position.

But the rifle is capable of more accuracy than you can achieve with iron sights, which is why this gun is not fully fleshed out until you have topped it with a 4x ACOG (Advanced Combat Optical Gunsight).  The Trijicon ACOG TA01 4x32mm scope is a standard military issue accessory.  And it is a beautiful piece of hardware: It produces a bright, clear image with good eye relief.  The reticle includes a bullet-drop compensator and is tritium-illuminated so that you can use it in dark conditions.  It mounts directly in the carry handle of an AR-15 using just one screw (and even leaves a hole through which you can still use the iron sights).  It is rugged, waterproof, and warrantied for life.  It is a perfect match for the .223 assault rifle.  But it is not cheap: I waited and managed to get one for $580 on Gunbroker.com, but unless you’re lucky you’ll probably have to pay at least $700 to pick one up new.

Suppressor

There are many options for suppressing this gun.  A lot of them are “quick-detach” cans, which can be installed with a single hand and a single twist onto a special flash hider, but these options generally cost at least $300 more than screw-on silencers.  Since it’s more hazardous to shoot a gun without a suppressor, I can’t think of a reason I would want to quickly remove mine, so I went with a screw-on can.  Since Gemtech has a good reputation and reasonable prices, I chose their $500 M4-02 “Piranha” model baffle suppressor.  It makes the rifle quiet enough to shoot without ear protection.  Though since the rifle shoots around 3000fps, it is by no means quiet: The sonic crack of the bullet makes roughly as much noise as a .22 being fired out of an unsuppressed gun.  But since that sound comes from the bullet’s shockwaves reflecting off of surfaces downrange it is much more subdued than if the shot were going off right by your ear.

Shooting an unsuppressed rifle — even one like the AR-15 with a reputation for very controlled recoil — is a violent experience.  In addition to the jarring recoil there’s a deafening report coupled with the palpable shock of propellant exploding from the muzzle.  Even with a good flash hider it can be disorienting.  Now putting this silencer on the end of the barrel absorbs practically all of the muzzle blast and a lot of the remaining recoil, making shooting almost … peaceful.  One drawback, other than the weight (a full pound for this particular can, protruding an extra 6″ beyond the end of the barrel), is the heat: After just ten successive shots the suppressor becomes too hot to hold with bare hands.  Keep shooting and it starts to radiate a heat mirage that can actually interfere with the sight picture if you’re trying to make a precise group.  (But it’s just doing its job: Here’s a good picture of a red-hot suppressor after hundreds of rounds of sustained, full-auto rifle fire.)

Ammunition

Guns rated for NATO 5.56mm also shoot .223 caliber ammunition.  (These have the same dimensions, but different pressure specifications.)  Since this is a standard military round it is both cheap and plentiful.  Right now you can find it in case lots for as little as $.20/round.  Most mil-spec ammo is 55gr FMJ, which leaves the muzzle of my 16″ barrel right about 3000fps.  I have also chronographed Georgia Arms’ 68gr match-grade BTHP at just over 2600fps.  Unfortunately, with all the ammunition I have tried I have never managed to shoot better than 3 MOA with this gun (that’s 1.5″ groups at 50 yards), though I don’t know if that’s typical.

Drawbacks

You have to keep it clean.Field-stripped AR-15 The best critique of the AR-15 is a Mad Ogre classic (overboard, but they are fair complaints).  The biggest criticism can be summarized as, “The rifle defecates where it eats.”  This was due to a design trade-off (direct gas cycling) made to keep the rifle lighter and simpler.1 It results in a lot more carbon fouling in the action than you would get with a piston design.  But you don’t really have to spend 4 hours a day cleaning the gun to keep it from jamming.  (Unless you’re dragging it through mud and sand … in which case you’re probably a G.I. with four hours a day to spend cleaning it.)  In my experience if you field strip it and scrub it down with Breakfree CLP after every shooting trip it will continue to function reliably.

You will probably come across criticism of the 5.56mm cartridge.  A lot of people say you have no business putting anything smaller than 7.62mm in an assault rifle.  Again, this is a trade-off: 210 rounds of 5.56mm weigh the same as 70 rounds of 7.62mm; 7.62mm assault rifles have to be bigger and heavier to handle the larger rounds.  My reasoning: If you need to kill in one shot, and weight isn’t an issue, then use a sniper rifle.  To say that a gun doesn’t shoot the biggest round in existence is an observation, not a criticism.  (Moreover, for purposes of suppression the lower the bullet diameter the better.)

Features:

  • Light, standard weapon.  Everyone knows how to use it, fix it, and enhance it.
  • Light, cheap, plentiful ammunition.
  • Relatively easy to shoot accurately (for a large-capacity semi-auto rifle).
  • Military-spec, proven and durable design.

Drawbacks:

  • Soils itself.
  • Doesn’t operate well when not maintained.

In spite of these drawbacks, there’s a reason that this has been the standard U.S. infantry long arm for over forty years.  Every country that can afford to equip its soldiers with AR-15 variants does.  As far as I know this is still the best militia weapon you can buy: Any alternative will be heavier, less reliable, and/or more complicated.  If you need a light rifle for tactical operations — which includes the ability to easily carry and shoot a lot of rounds — then take an AR-15.

[Update: Added a CMC Match Trigger Group to improve the trigger pull.]


1 Many companies have just recently brought gas-piston systems to the market for these guns.  See details in the comments.

17 thoughts on “AR-15 with Trijicon ACOG and Gemtech M4-02 Suppressor

  1. federalist

    Great reference site is the Maryland AR-15 Shooters site.

    Apparently there is a growing market for gas-piston AR-15’s. One AR15.com post summarizes:

    Leitner-Wise
    POF USA
    ARES

    You can either buy a LW complete piston upper or they can convert your DI upper. POF only sells complete piston uppers. ARES is a drop-in kit that doesn’t require any major tools. ARES is the lowest cost at $400 for the entire kit.

    Colt is supposed to be releasing their piston rifle soon but as of yet it is not available. The HK416 is not available to civilians (as of right now).

    LW and POF both have excellent reviews and reliability, however, ARES just came out so reviews and reliability are unknowns right now.

    Another intriguing new rifle frequently referenced is the XCR.

    Reply
  2. Pingback: CMC AR-15 Super Match Trigger Group « Consumer Maven

  3. Pingback: EmptorMaven » Blog Archive » CMC AR-15 Super Match Trigger Group

  4. federalist

    Ruger just came out with a piston-action AR-15 derivative they’re calling the SR-556 (see GunBlast review here). It comes with all the right fixings and should sell around $1600, which would make it the most attractive piston AR-15 on the market.

    (Note, however, that it still has the drawback common to all AR-15 lowers which is that they don’t allow for a folding stock because the buffer spring has to extend into the stock. For that reason the roughly $1600 XCR is still preferable, though it lacks full compatibility with the extensive AR-15 parts market.)

    Reply
  5. Pingback: EmptorMaven » Blog Archive » Tactical Rifle: Ruger SR-556

  6. Pingback: EmptorMaven » Blog Archive » Rethinking Direct Impingement with the Noveske 300 BLK Upper

Leave a Reply

Your email address will not be published. Required fields are marked *